temporality

This module is a mapping of the AggregationTemporality field in CNCF OpenTelemetry trace spans. The text of the specification has been copied into this mapping for convenience.

Where text from the CNCF OpenTelemetry specification is used it is provided in block quotes.

From the specification:

AggregationTemporality defines how a metric aggregator reports aggregated values. It describes how those values relate to the time interval over which they are aggregated.

Constants

delta

type: U64

DELTA is an AggregationTemporality for a metric aggregator which reports changes since last report time. Successive metrics contain aggregation of values from continuous and non-overlapping intervals.

The values for a DELTA metric are based only on the time interval associated with one measurement cycle. There is no dependency on previous measurements like is the case for CUMULATIVE metrics.

For example, consider a system measuring the number of requests that it receives and reports the sum of these requests every second as a DELTA metric:

1. The system starts receiving at time=t_0.
2. A request is received, the system measures 1 request.
3. A request is received, the system measures 1 request.
4. A request is received, the system measures 1 request.
5. The 1 second collection cycle ends. A metric is exported for the number of requests received over the interval of time t_0 to t_0+1 with a value of 3.
6. A request is received, the system measures 1 request.
7. A request is received, the system measures 1 request.
8. The 1 second collection cycle ends. A metric is exported for the number of requests received over the interval of time t_0+1 to t_0+2 with a value of 2.

cumulative

type: U64

CUMULATIVE is an AggregationTemporality for a metric aggregator which reports changes since a fixed start time. This means that current values of a CUMULATIVE metric depend on all previous measurements since the start time. Because of this, the sender is required to retain this state in some form. If this state is lost or invalidated, the CUMULATIVE metric values MUST be reset and a new fixed start time following the last reported measurement time sent MUST be used.

For example, consider a system measuring the number of requests that it receives and reports the sum of these requests every second as a CUMULATIVE metric:

1. The system starts receiving at time=t_0.
2. A request is received, the system measures 1 request.
3. A request is received, the system measures 1 request.
4. A request is received, the system measures 1 request.
5. The 1 second collection cycle ends. A metric is exported for the number of requests received over the interval of time t_0 to t_0+1 with a value of 3.
6. A request is received, the system measures 1 request.
7. A request is received, the system measures 1 request.
8. The 1 second collection cycle ends. A metric is exported for the number of requests received over the interval of time t_0 to t_0+2 with a value of 5.
9. The system experiences a fault and loses state.
10. The system recovers and resumes receiving at time=t_1.
11. A request is received, the system measures 1 request.
12. The 1 second collection cycle ends. A metric is exported for the number of requests received over the interval of time t_1 to t_0+1 with a value of 1.

Note: Even though, when reporting changes since last report time, using CUMULATIVE is valid, it is not recommended. This may cause problems for systems that do not use start_time to determine when the aggregation value was reset (e.g. Prometheus).

unspecified

type: U64

The default AggregationTemparality - it must not be used conforming implementation will set the temporality to one of the valid enumeration values.